Pressure Tank Switch Wiring

Turns pump on at 40 psi off at 60 psi.

Pressure tank switch wiring.

This method will work for any pump that runs directly off of a pressure. Flip the breaker to the pump switch and check it with a voltage sniffer to make sure it s off. It will likely be mounted on the outside of your pressure tank. Wrap the pipe threads with teflon tape and reassemble.

It can be wired 115 volt or 230 volt. Over time a square d pressure switch can become worn out. The air pressure in the well tank when empty of all water must be set to 38 psi or the switch will not operate properly. Then drain the pressure tank.

This switch is to be used with submersible well or jet pumps. Water pressure switches in well systems control the amount of water pumped to the system s storage tank. A square d pressure switch is what controls the pump. When the tank reaches its peak pressure typically at 60 pounds per square inch the switch cuts the electrical power to the water pump.

If your pump isn t switching on or off properly it may well be to do with your square d pressure switch. This switch must be used in conjunction with a well pressure tank. An older pressure switch can lead to issues with your pump. As the tank is filled the water pressure increases within it.

Next remove the old switch photo 2 and gauge photo 3.