Pull Up Wood Floor Without Damaging

Determine the direction of the tongue and groove hardwood installation so you can reverse the process as you remove hardwood flooring.

Pull up wood floor without damaging.

If the floor has spaces in between the boards you can get a saw in there to cut between the boards. Then move to the next nail and do the same thing. Repeat this process until all the flooring has been removed. But you should use the best nail kicker to follow this process.

Geekstreet diy removeflooring how to remove tounge and groove flooring without damaging https www amazon co uk shop geekstreet. Near a nail slide the pry bar underneath the board and elevate about inch. With the right nail kickers you can remove nails very fast. One type of flooring prone to long term damage so ripe for demo is a floating wood floor.

The reason i couldn t lift up a piece of this hardwood flooring easily is because of how tightly it is laid down. The first thing i had to do was knock down a couple of finishing nails that were sticking up. Pry up a board with an exposed tongue. Wedge the tip of the pry bar underneath a section of flooring.

Use a pry bar to pull up the boards. Pull back sharply on the handle to wrench the board from its place. Pull the piece off of the adjoined strip once you feel it come loose at the joint then set it aside out of the way. Pulling the laminate strip up and back at an angle will unhook it from the connected piece so you can then lift it away.

Pull up heat vents to expose the cut edge of the flooring. Assuming you ve sawed the boards into small enough sections they should pop right out. A floating floor system has floor planks that are snapped or glued to each other but are not attached. Though setting up nail kickers is time consuming once you set it up you can quickly and smoothly remove nails.

These may also be reused if you are careful and don t damage them during removal. And the best part about it is you can remove nails without damaging your wood. Lay the padding on top of the carpet strip and roll them both up into a jelly roll once there stand the roll on end and tape or tie it in such a way that it won t unroll. Now that you have the strip of carpet pulled up set it to one side and pull up the padding using the same cut life and pull method.

Lift the laminate strip up and away to separate it from the connected piece.